1. Traffic markings are divided into indication, warning and prohibition.
A. Right
B. Wrong
Answer：A
2. Which is correct if a vehicle breaks down and is difficult to move?
A. turn on the hazard lights
B. turn on all the lights of the vehicle
C. forbid the passengers to get off
D. place a warning sign in front of the vehicle
Answer：A
3. What is the time limit of deferred license checking due to military service, abroad and other reasons?
A. 3 years
B. 5 years
C. 1 years
D. 2 years
Answer：A
4. How to use lights in this weather condition?
A. use high beam lights
B. use fog lights
C. not use any light
D. turn on the right-turn signal
Answer：B
5. What is this instrument?
A. speed and mileage meter
B. engine tachometer
C. top speed meter
D. fuel consumption / 100 km
Answer：A
6. What is the max speed on this highway?
A. 30km/hr
B. 40km/hr
C. 50km/hr
D. 70km/hr
Answer：D
7. Whats the meaning of this sign?
A. stop by the left side of the road
B. downhill section left
C. left turn only
D. run by the left side of the road
Answer：D
8. Whats the meaning of this sign?
A. no U turn at intersection
B. no changing lane from both sides
C. no left or right turn
D. no going straight
Answer：C
9. When driving at night, the driver should reduce speed and go forward if the vehicle coming in the opposite direction fails to turn off the high beam light. This is designed to prevent an accident from happening when there are pedestrians crossing the place where the lights of the two vehicles meet.
A. Right
B. Wrong
Answer：A
10. When passing an unmanned level crossing, the driver should ________.
A. Speed up and pass
B. Reduce speed and pass
C. Maintain the speed and pass
D. Stop, look and pass
Answer：D
11. Whats the meaning of this sign?
A. lane direction indication
B. intersection ahead
C. lane information indication
D. road branching point ahead
Answer：B
12. Whats the meaning of this sign?
A. reduce speed in tunnel
B. turn on the high beam lights in tunnel
C. turn on the light in tunnel
D. width light in tunnel
Answer：C
13. When following a vehicle, the following vehicle may use the high beam light.
A. Right
B. Wrong
Answer：B
14. How to use lights when pulling over on road?
A. turn on the hazard lights
B. turn on the right-turn signal in advance
C. use the high and low beam lights alternately
D. not need to use any light to indicate
Answer：B
15. What is this manipulation device?
A. switch of reverse light
B. switch of wiper
C. switch of the hazard lights
D. combination switch of lights and signals
Answer：D
16. How to run when encountering this situation at the intersection?
A. stop and wait
B. obey the traffic lights
C. run straight on the right side
D. may turn right
Answer：A
17. Using the low beam light in such circumstances.
A. Right
B. Wrong
Answer：A
18. Rear fog light lights when the light switch is at this position.
A. Right
B. Wrong
Answer：A
19. When the driver senses a tire blowout on the road, he should control the direction of the vehicle, gently depress the brake pedal to slowly reduce the speed and gradually park the vehicle steadily on the roadside.
A. Right
B. Wrong
Answer：A
20. This sign reminds the width of the bridge narrows ahead.
A. Right
B. Wrong
Answer：B
21. The safety pillow is used to protect the driver‘s head when there is a rear-end collision.
A. Right
B. Wrong
Answer：B
22. This set of the hand signals of the traffic police indicates that the vehicles should ___ .
A. turn right
B. reduce speed and pass slowly
C. pull over
D. change lane
Answer：D
23. What is the main role of the seat belt when there is a collision?
A. to protect the driver and passengers necks
B. to protect the driver and passengers chests
C. to reduce the injuries of the driver and passengers
D. to protect the driver and passengers waists
Answer：C
24. Stopping temporarily on the road should not obstruct the passing of other vehicles and pedestrians.
A. Right
B. Wrong
Answer：A
25. This set of the hand signals of the traffic police indicates that the vehicles should ____ .
A. wait to turn left
B. pull over
C. turn left
D. turn right
Answer：C
