1. What is this manipulation device?

A. switch of windscreen wiper

B. switch of the head lights

C. switch of the turn signal

D. switch of defogger

Answer：A

2. When a vehicle overtakes the bike riders going in the same direction, the rational way to deal with is to ________.

A. Continuously honk to remind them to yield

B. Continuously honk and speed up to overtake

C. Yield to the bike riders

D. Observe them, reduce speed and go slowly, while keeping a sufficient safe distance.

Answer：D

3. How to pass through the unmanned level crossing without traffic lights?

A. properly reduce speed to pass

B. slide over in the neutral gear

C. stop to make sure it is safe, then pass

D. speed up and pass as fast as possible

Answer：C

4. Which part of the driver can be protected by the safety pillow when there is a rear-end collision?

A. waist

B. chest

C. head

D. neck

Answer：D

5. The vehicle with ABS system can minimize the braking distance when driving on a road covered by ice and snow.

A. Right

B. Wrong

Answer：B

6. Whats the meaning of this sign?

A. landslide section

B. construction section

C. factory ahead

D. jammed road

Answer：B

7. Reducing the speed to yield when encountering this situation in the intersection.

A. Right

B. Wrong

Answer：A

8. This sign reminds there is a ferry ahead for vehicles.

A. Right

B. Wrong

Answer：A

9. The oil pressure of engine may be too high if it lights.

A. Right

B. Wrong

Answer：B

10. This sign indicates one-way section ahead.

A. Right

B. Wrong

Answer：B

11. After a vehicle enters a mountain road, it should pay special attention to the continuous curves sign. In addition, it should voluntarily evade vehicles and pedestrians, reduce speed in a time manner and honk in advance.

A. Right

B. Wrong

Answer：A

12. When a vehicle leaves an expressway, it should reduce speed in the deceleration lane before entering the ramp.

A. Right

B. Wrong

Answer：A

13. When the driver senses a tire blowout on the road, he should control the direction of the vehicle, gently depress the brake pedal to slowly reduce the speed and gradually park the vehicle steadily on the roadside.

A. Right

B. Wrong

Answer：A

14. Whats the meaning of this sign?

A. bump road

B. high outburst road

C. low-lying road

D. hump bridge

Answer：B

15. Whats the meaning of this sign?

A. straight-going lane

B. going straight only

C. one-way road

D. no going straight

Answer：B

16. Continuously using the foot brake on a long downhill road ________.

A. Can shorten the engines service life

B. Increases the drivers labor intensity

C. Can drastically reduce the braking efficiency due to the rising temperature of the brake

D. Can easily cause vehicle overturn

Answer：C

17. When a motorized vehicle breaks down on the road and is difficult to move, the driver should place a warning sign within 50 meters behind the vehicle.

A. Right

B. Wrong

Answer：B

18. When overtaking, the driver should ________ if the vehicle in front refuses to reduce speed or yield.

A. Follow closely and find chance to overtake again

B. Stop overtaking

C. Speed up and continue to overtake

D. Continuously honk and speed up to overtake

Answer：B

19. Whats the meaning of this sign?

A. stop to get card

B. stop to pay

C. ETC lane

D. stop for inspection

Answer：A

20. What is the max speed on this highway?

A. 30km/hr

B. 40km/hr

C. 50km/hr

D. 70km/hr

Answer：D

21. One shall not drive a motorized vehicle during the period of deferred license checking due to military service, abroad and other reasons.

A. Right

B. Wrong

Answer：A

22. Max speed when pass the narrow road or bridge is _______

A. 50km/hr

B. 40km/hr

C. 30km/hr

D. 60km/hr

Answer：C

23. What is the max speed on muddy road?

A. 15km/hr

B. 20km/hr

C. 40km/hr

D. 30km/hr

Answer：D

24. When a vehicle approaches a crosswalk, the driver should ________.

A. Speed up and pass

B. Stop immediately

C. Honk to indicate the pedestrians to yield

D. Observe the movement of pedestrians and non-motorized vehicles, make sure it is safe before passing

Answer：D

25. It lights to indicate that ______

A. left-turn signal flashes

B. front and rear width lights light on

C. front and rear width lights light on

D. right-turn signal flashes

Answer：A