1. It lights to indicate that ______
A. not buckled up
B. safety belt malfunction
C. the safety belts are too loose
D. buckled up already
Answer：A
2. It lights to remind that the driver has not buckled up.
A. Right
B. Wrong
Answer：A
3. What marking is the road mark in the circle?
A. crosswalk line
B. slowdown and yield line
C. stopping and yield line
D. intersection signal line
Answer：A
4. When a vehicle stops temporarily in a rainy day, the driver should turn on ______.
A. The head and tail fog lights
B. The hazard lights
C. The high beam light
D. The reverse light
Answer：B
5. This set of the hand signals of the traffic police indicates that the vehicles should ___ .
A. go straight
B. make a turn
C. stop
D. pull over
Answer：A
6. Which part does this switch control?
A. windscreen defogger
B. windscreen wiper
C. the hazard lights
D. devices of lights and signals
Answer：B
7. What is this manipulation device?
A. the handbrake
B. the air throttle lever
C. the gear lever
D. the clutch lever
Answer：C
8. What is the Minimum speed in this lane?
A. 100km/hr
B. 110km/hr
C. 60km/hr
D. 90km/hr
Answer：D
9. This sign reminds the road in front changes to inseparate two ways section.
A. Right
B. Wrong
Answer：A
10. May turn right when encountering this traffic light at the intersection.
A. Right
B. Wrong
Answer：A
11. Which kind of sign is it?
A. warning sign
B. prohibitive sign
C. indicative sign
D. directional sign
Answer：C
12. When ignition switch is in the START position, the starter starts.
A. Right
B. Wrong
Answer：A
13. As thick fog reduces visibility, turning on the high beam light can increase the visibility.
A. Right
B. Wrong
Answer：B
14. When a vehicle is being overtaken by another vehicle, and there is a vehicle following behind, the driver should _____.
A. continue to speed up and run
B. turn slightly to the right side, keep a safe horizontal distance
C. run by road center
D. speed up to the right side to yield
Answer：B
15. This sign warns a sharp left curve ahead.
A. Right
B. Wrong
Answer：A
16. When a vehicle on the main road approaches a conjunction with a feeder road, the driver should ______ in order to prevent a collision with a vehicle that suddenly enters from the feeder road.
A. Maintain the normal speed
B. Reduce speed in advance, observe and drive with care
C. Honk and swiftly pass
D. Speed up in advance and pass
Answer：B
17. When the road maintenance vehicle and the engineering vehicle are on duty, the passing vehicles should avoid with care.
A. Right
B. Wrong
Answer：A
18. This sign reminds bump road ahead which may causes bump phenomenon.
A. Right
B. Wrong
Answer：A
19. Whats the meaning of this sign?
A. straight-going lane
B. going straight only
C. one-way road
D. no going straight
Answer：B
20. No turning left in this situation.
A. Right
B. Wrong
Answer：A
21. Which of the following vehicle in front in the same lane is not allowed to be overtaken?
A. the vehicle is making a stop
B. the vehicle is reducing speed to yield
C. the vehicle is taking a U turn
D. the vehicle is running normally
Answer：C
22. Reduce speed or stop to look before the stop line when encountering this traffic light at the intersection.
A. Right
B. Wrong
Answer：B
23. Whats the meaning of this sign?
A. distance to a tourist area
B. direction of a tourist area
C. symbol of a tourist area
D. category of a tourist area
Answer：A
24. Whats the meaning of the white rectangle marking?
A. special space for taxicabs to take and drop passengers
B. horizontal parking space
C. inclined parking space
D. vertical parking space
Answer：B
25. You can overtake from both sides in this case.
A. Right
B. Wrong
Answer：B
